See the below attached files for quick-start guides to using the molbox/molbloc flow calibration system.
- Quick start guide for laminar molbloc elements with low pressure calibration
- Quick start guide for laminar molbloc elements with high pressure calibration
- Quick start guide for laminar molbloc elements with downstream calibration
Refer to the calibration reports for your laminar molbloc elements to see what type of calibration(s) they have on them.
Note that these quick start guides are not for sonic molbloc elements.
See the molbox1+ or molbox RFM flow terminal Operation and Maintenance Manual for detailed information and instructions.
See this article for summary information of molbloc calibrations, and how the molbox/molbloc flow calibration system works,
Fundamentals - molbloc / molbox (theory, requirements, cal's)
Revised 13-September-2016 to add a step to choose the GAS and calibration in step 2.
Revised 05-December-2017 to add choice of UNIT to step 1, and show a manual control valve on the diagram.
Word(r) documents are also attached if you wish to edit for your own work instructions, etc.
If you need additional assistance please click on the "Submit a request" link below or contact Flow Calibration Technical Support by phone at +1.877.355.3225